| myArmoury.com is now completely member-supported. Please contribute to our efforts with a donation. Your donations will go towards updating our site, modernizing it, and keeping it viable long-term.
Last 10 Donors: Anonymous, Daniel Sullivan, Chad Arnow, Jonathan Dean, M. Oroszlany, Sam Arwas, Barry C. Hutchins, Dan Kary, Oskar Gessler, Dave Tonge (View All Donors) |
| Author |
Message |
|
Ondrej Borsky
Industry Professional
|
 Posted: Mon 26 Sep, 2016 11:43 am Post subject: Knife blades available for DIY finishing |
 |
|
Hello!
I have made a few really simple blades, for a DIY finishing. I remeber when I started reenacting, all the blades were quite expensive for me, and so I tried to come up with something affordable  All the blades are from spring steel, and all have been hardened, tempered and sharpened and have a surface finish of cca 320grit.
The Brokenback: length: 12,7cm, width: 26mm to 33mm, thickness: 4,8mm to 5,8mm. Price: 37E/41USD + shipping
The III: length: 11,9cm, width: 24,5mm, thickness: 5,8mm. Price: 32E/36USD + shipping
The last one: length: 11,2cm, width: 22mm, thickness: 5,8mm. Price: 30E/34USD + shipping
Thank you for looking!
|
|
   |
 |
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum
|
All contents © Copyright 2003-2024 myArmoury.com — All rights reserved
Discussion forums powered by phpBB © The phpBB Group
Switch to the Basic Low-bandwidth Version of the forum
|
This is a standard topic
