Info Favorites Register Log in
myArmoury.com Discussion Forums

Forum index Memberlist Usergroups Spotlight Topics Search


myArmoury.com is now completely member-supported. Please contribute to our efforts with a donation. Your donations will go towards updating our site, modernizing it, and keeping it viable long-term.
Last 10 Donors: Graham Shearlaw, Anonymous, Daniel Sullivan, Chad Arnow, Jonathan Dean, M. Oroszlany, Sam Arwas, Barry C. Hutchins, Dan Kary, Oskar Gessler (View All Donors)

Forum Index > Off-topic Talk > Riveted Maille and Padded Jack Tests (very photo intensive) Reply to topic
This is a Spotlight Topic Go to page Previous  1, 2, 3 ... 9, 10, 11 
Author Message
William P




Location: Sydney, Australia
Joined: 11 Jul 2010

Posts: 1,525

PostPosted: Thu 03 May, 2012 6:10 pm    Post subject:         Reply with quote

T. Arndt wrote:
William P wrote:

sorry if this seems a silly question but, all these thrust tests.. were you thrusting at only the spanish made rivited maile, or the indian maile as well as the spanish one?

and out of curiosity, did you cut the the indian maile with either the sword or the pollaxe out of curiosity?


Isn't your answer below the picture of the three rings that are broken at at rivet?

Michael Edelson wrote:
These results are far superior to the imported Indian 9.5mm riveted hauberk I tested earlier. That hauberk could not stop the bow at 50lbs and 20 feet, nor did it stop any of the arrows at 20 yards, though it did rob them of enough force that the gambeson was able to defeat half of them. I later tested that hauberk at 70lbs and each arrow at both ranges easily defeated it. This maille, much more historically correct and of stouter rings with better quality riveting defeated every arrow shot at 50lbs and all of the arrows shot at 70lbs from 20 yards. The difference between them is literally life and death.


ill take that as a yes its the spanish maile,
but no, sadly its NOT obvious to me.
View user's profile Send private message Send e-mail
Will White




Location: Staffordshire
Joined: 10 Jun 2012

Posts: 6

PostPosted: Fri 29 Jun, 2012 6:05 pm    Post subject: Riveted Maille and Padded Jack Tests (very photo intensive)         Reply with quote

If you'r looking for period arrows/heads and bows here you go[http://www.archery-centre.co.uk]. And there is a show wich although is not the best historically but occasionally they do some interesting tests[http://deadliestwarrior.wikia.com] Worried Happy
The scariest moment is always just before you start.
Stephen King
View user's profile Send private message
Alexis Bataille




Location: montpellier
Joined: 31 Aug 2014

Posts: 95

PostPosted: Tue 14 Jul, 2015 12:45 pm    Post subject:         Reply with quote

Perhaps some one can enlighten me :
it appears after all my reading that mail & linen is more easily defeated by arrows than by sword trust with the roughly same kinetic energy even with acute sword points .
Did i miss something ?
View user's profile Send private message
Dan Howard




Location: Maitland, NSW, Australia
Joined: 08 Dec 2004

Spotlight topics: 2
Posts: 3,644

PostPosted: Tue 14 Jul, 2015 2:31 pm    Post subject:         Reply with quote

I don't see anything to suggest that a one-handed sword thrust delivers the same amount of energy as a war bow.
Author: Bronze Age Military Equipment, Pen and Sword Books
View user's profile Send private message
Alexis Bataille




Location: montpellier
Joined: 31 Aug 2014

Posts: 95

PostPosted: Tue 14 Jul, 2015 4:05 pm    Post subject:         Reply with quote

Ok i miss that, energy from warbow are easy to find but one handed thrust there is big variations i read 120 for overhand thrust somewhere then 20-40 joules in another book. So i guess its more around 70 joules perhaps. I know its very dependent of techniques, skill and fitness of the striker but even trained modern fencer struggle to pierce good mail. So ok warbows deliver much more energy than one handed thrust (and perhaps two handed too, i see some halfswording-trust with acute swords fail to pierce mail too).
Thanks
View user's profile Send private message
Benjamin H. Abbott




Location: New Mexico
Joined: 28 Feb 2004

Spotlight topics: 1
Posts: 1,248

PostPosted: Tue 14 Jul, 2015 9:36 pm    Post subject:         Reply with quote

We don't really have the data for such comparisons at the moment. The stab-test kinetic energy figures come from random people who tried a stab or three with a rather heavy instrumented knife with a handle similar to some swords. I have a feeling people who train to stab powerfully like people train to shoot warbows would do better. What percentage of random folks could effectively draw and shoot a 150lb bow?

I think it's probably correct that yew warbows hit harder than single-handed sword thrusts at the same level of strength and training, but I'd like tests that clearly show this. Some period sources equate arrows and swords for piercing armor, while others indicate greater penetrate potential for arrows. The couched lance and sometimes the crossbow get the highest regard in this respect. (Monte apparently considered the first pass of the lance and crossbows the most dangerous. Barwick gave that account of a lance impaling a man wearing a coat of plates, which he thought equivalent to brigandine. Etc.)
View user's profile Send private message
Alexis Bataille




Location: montpellier
Joined: 31 Aug 2014

Posts: 95

PostPosted: Tue 14 Jul, 2015 11:13 pm    Post subject:         Reply with quote

I agree about the lack of data , but it seems that untrained tester pierce chain mail with more ease with a bow than with a sword / spear trust. Probably bow is a better tool for a one shot thrust than a pointy stick, i can accept that.
View user's profile Send private message
Bartek Strojek




Location: Poland
Joined: 05 Aug 2008
Likes: 23 pages

Posts: 497

PostPosted: Wed 15 Jul, 2015 10:34 am    Post subject:         Reply with quote

Even with same energy, sword stab and arrow shot will be completely different impacts, so it's really hard to compare them 'theoretically'.

Vastly different masses, velocities, momentum, stiffness, presence, densities and so on.

And as far as linen goes, in this particular tests it falls to swords way, way more easily than to arrows, so not sure what you are referring to with arrows being 'better'.

Of course, those round, blunt arrowheads probably are pretty terrible as far cutting textiles.
View user's profile Send private message
Dan Howard




Location: Maitland, NSW, Australia
Joined: 08 Dec 2004

Spotlight topics: 2
Posts: 3,644

PostPosted: Wed 15 Jul, 2015 2:59 pm    Post subject:         Reply with quote

The tests against linen aren't much use because the samples weren't quilted properly. This is covered in other recent threads. Proper linen armour starts off at anywhere from 1-4 fingers thick and is then compressed down with quilting so that it is half that thickness. The amount of quilting is substantial and very dense - it isn't just a few rows spaced a few inches apart.
Author: Bronze Age Military Equipment, Pen and Sword Books
View user's profile Send private message
Timo Nieminen




Location: Brisbane, Australia
Joined: 08 May 2009
Likes: 1 page
Reading list: 1 book

Posts: 1,504

PostPosted: Wed 15 Jul, 2015 4:44 pm    Post subject:         Reply with quote

Benjamin H. Abbott wrote:
The stab-test kinetic energy figures come from random people who tried a stab or three with a rather heavy instrumented knife with a handle similar to some swords.


These instrumented knives don't measure kinetic energy. They measure the work done during the stab. Depending on exactly where the force sensor is, it might or might not include the initial (rather low) kinetic energy of the knife before contact (usually, it would include part of it).

"Stab energy" is OK, but not easy to compare with arrow kinetic energies. Given the same point geometry and size, "equal penetration for equal energy" will only apply if the target doesn't move significantly during the strike/impact. For a fixed target, this will be true. For armour worn by a person, a relatively slow stab will allow the person/armour to move a lot more than a fast arrow. In this case, a lot of the energy goes into moving the target, not penetrating the target.

Some of the variation in stab energy values come from how much the target can move. Typically, the "knife" uses a force sensor, and work = force x distance is used to calculate the energy. If the target moves, that distance will be high, and the energy will be high. But that's the energy that moves the target, rather than damaging the target.

Human + sword is a much more complicated system than an arrow.

"In addition to being efficient, all pole arms were quite nice to look at." - Cherney Berg, A hideous history of weapons, Collier 1963.
View user's profile Send private message Visit poster's website
Benjamin H. Abbott




Location: New Mexico
Joined: 28 Feb 2004

Spotlight topics: 1
Posts: 1,248

PostPosted: Mon 20 Jul, 2015 9:59 am    Post subject:         Reply with quote

Yep, good point about energy. As far as both period texts and tests go, there's some other evidence that two-handed staff weapons could/can hit as hard as or harder than than arrows from at least self bows. A 17th-century English colonial text from the land now claimed as the U.S. Northeast noted a particular Amerindian arrow shot struck a breastplate as if it had been pushed by pike, thus implying that pikes typically hit harder than arrows or at least assuming an equivalence. Similarly, a test of a circa-1600 halberd against a 16th-century munitions-quality infantry harness managed penetration of breastplate with halberd's top spike. This test achieves penetration of 1.5mm (or 1.6mm) mild steel with various polearm top spikes. By Alan Williams's figures, piercing 1.5mm mild steel requires 105 J with a 18-degree point (simulated arrowhead). 105 J is respectable figure for a yew warbow.
View user's profile Send private message
Alexis Bataille




Location: montpellier
Joined: 31 Aug 2014

Posts: 95

PostPosted: Tue 21 Jul, 2015 12:42 am    Post subject:         Reply with quote

At least 105 joules yes, with a 5-6 lb poleaxe plus steel gauntlets plus the "armour" weight.
View user's profile Send private message
Nathan Robinson
myArmoury Admin


myArmoury Admin

PostPosted: Sat 01 Apr, 2017 9:06 pm    Post subject:         Reply with quote

Many of the photos found in this topic's original posts have been restored. There's still a couple missing. We'll be contacting the author to see if they can be found and uploaded.
.:. Visit my Collection Gallery :: View my Reading List :: View my Wish List :: See Pages I Like :: Find me on Facebook .:.
View user's profile Send private message Send e-mail Visit poster's website
Michael Kornecki





Joined: 31 Mar 2017

Posts: 1

PostPosted: Sun 02 Apr, 2017 1:40 am    Post subject:         Reply with quote

Thank you both for your time and effort!
Michael
View user's profile Send private message Send e-mail


Display posts from previous:   
Forum Index > Off-topic Talk > Riveted Maille and Padded Jack Tests (very photo intensive)
Page 11 of 11 Reply to topic
Go to page Previous  1, 2, 3 ... 9, 10, 11 All times are GMT - 8 Hours

View previous topic :: View next topic
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum






All contents © Copyright 2003-2024 myArmoury.com — All rights reserved
Discussion forums powered by phpBB © The phpBB Group
Switch to the Basic Low-bandwidth Version of the forum