[Klaus Jürgen Gehr]

Here is a new setup I have been using the last few days to do some burring/fluting
on compound places on the armour. I am sure some other people played with this.
I do not like the inside look I get, it looks ok on the out side.
I played with the chiesel angle and the grove with the like.
But it changed very little.
I will make a new bottom piece with two piece of stainless round stock and
TIG it on a new piece.
I believe it will clean up better. This way the chiesel will hit between the
two round stock pieces.
Does any body have any better Ideas ?
Klaus