| Author |
Message |
Etienne Hamel
Location: Granby (QC) canada Joined: 09 Sep 2006
Posts: 443
|
 Posted: Tue 05 Jan, 2010 8:30 am Post subject: Hafting a spear project |
 |
|
hi all, i'm currently profiling a haft for my long bladed spearhead and my flat buttcap from widlass but i have not money for stuff to do it properly so i'm using cement (basement floor as sanding paper works better than expecting) a file and a hand sanding machine ( took me 3 hours yesterday and did not finished the first side of the haft :lol: ).
after this project i'll have bionic arms hahaha!
|
|
  |
 |
A. Spanjer
|
| Posted: Tue 05 Jan, 2010 10:43 am Post subject: Re: Hafting a spear project |
|
|
| Etienne Hamel wrote: | | (basement floor as sanding paper works better than expecting) |
:lol: I do that all the time, it works great. Though I usually use the driveway instead.
|
|
|
|
|
|
Eric Fick
Location: California Joined: 16 Sep 2009
Posts: 78
|
| Posted: Tue 05 Jan, 2010 12:35 pm Post subject: |
|
|
A draw knife would help and be an invaluable tool for years to come. I know here in california I can only find then in antique shops but even still, it only cost me $5.00 for it and with just a little bit of TLC it works like a champ and lets me turn out halfts and shafts
just a thought, check ebay. Even if you go to an antique shop to get it, you know what to look for and how much it is on the internet. if you plan on doing more than one project this is well worth the money
good luck
Cheers,
Eric Fick
Davenriche European Martial Artes Schoole
www.swordfightingschool.com
|
|
|
|
|
Etienne Hamel
Location: Granby (QC) canada Joined: 09 Sep 2006
Posts: 443
|
| Posted: Tue 05 Jan, 2010 5:23 pm Post subject: |
|
|
|
i found a knife today and i should say it work better in approximately 30 min i have done the job i did in 3 hours :eek:
|
|
|
|
|
|
|
This is a standard topic