---

I'm putting up an Albion moat blade I purchased a couple of years ago. I believe it is an unfinished Baron blank. The blade is milled and fully tempered and heat treated, however it is lacking final finishing. There are extensive tool marks across it's surface, and the edges are still in the milled state at approximately 1.5 mm thick. The blade also has extensive rust residue.

Overall dimensions are as follows: Length 48.75" with a blade of 37.5", width at the base is about 2.25". This distal tapers starts at about 6mm at the base, reaching 2mm at the tip.

I'm looking for $300 for the blade, however please feel free to PM me with offers. Pictures are linked below.

http://s1376.photobucket.com/user/Jack_Ironha...=3&o=4

http://s1376.photobucket.com/user/Jack_Ironha...=3&o=0

http://s1376.photobucket.com/user/Jack_Ironha...=3&o=1

Cheers!