---

Hi everyone! The thread subject pretty much sums it up. I'm looking for an AT-1415 in good or better condition. If it's been cut with that's fine, as long as there aren't a lot of dings and dents. Patina is ok, and even rust if it's only on the surface. If you've got one you're willing to sell (or trade), drop me a pm. I'm only willing to pay through paypal.

Thanks,
Alan

---

I'm going to bump this. If anyone is interested in trades, I'm willing to trade a Del Tin project that I did using an Orcrist blade I got from the Albion moat sale and a Windlass Sword of Roven.

On the Del Tin, I ground off the ricasso and made it a hand and a half. The handle is poplar covered in veg-tanned leather dyed green. It also has a scabbard made of poplar and covered in the same leather. The dimensions are:
Overall length - 38 inches
Blade length - 30 inches
Hilt length - 8 inches
Blade width at base - 2 1/8 inches
Grip length - 7 1/8 inches
Weight - 2 lbs 12 ounces
PoB - 4 1/2 inches

On the Windlass, I redid the grip so it only has three risers, top, middle, and bottom. I also started sharpening it, but had to stop partway through and never got around to it again, so the edge isn't very sharp. Other than that, it is exactly the same as the stock model.

Here are pics:
Del Tin
[ Linked Image ]
[ Linked Image ]
Windlass
[ Linked Image ]

Again, if anyone is interested, please send me a pm.

Thanks,
Alan

---

Anybody? Please? With a cherry on top? :)

Thanks,
Alan