How do I anneal/normalize rivets for riveted maille?
I finally have a hauberk to go along with my coif and of course, I want to tailor it as well. When rebuilding my coif I noticed that riveting was sometimes hard, to which my supplier suggested that I anneal the rivets first.

But, how do I do that? I read how to anneal rings. String them on a wire and get them red hot with a blowtorch. But I can't string rivets up. Could I use a steel spoon? I'm a bit worried that the rivets are so tiny the blowtorch will blow them away, or that they cool too fast lying on a spoon and all.

Any tips? Thanks in advance!
Hi Sander!

I also anneal my rivets, while working with riveted maille.
For this purpose I use an ordinary tin from canned food - just put the rivets in the tin, heat them with a propane torch until turn red and after that I just leave them to cool.
The only important thing is to choose the tin carefully - if it's too big and deep the flame of the torch sometimes could extinguish by itself. For example my tin is approx. two fingers (3 - 3.5 cm) deep and this is quite enough.

Of course the tin is not the only option - you could use every shallow steel volume you have in reach. And you are worried about the speed of cooling - you could just repeat heating several times.
Thanks! Good to know that canned food tins work. Saves me a few bucks from ruining a perfectly good spoon :-)

Page 1 of 1

Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum




All contents © Copyright 2003-2006 myArmoury.com — All rights reserved
Discussion forums powered by phpBB © The phpBB Group
Switch to the Full-featured Version of the forum