XIV blade DIY project
Hello all!
So, I thought I'd finally open this up to the myArmoury community, especially since this has been my primary source of information regarding swords and their manufacturing. That said, I've begun a stock removal project. The finished piece will be a type XIV blade. I'm looking at an R type pommel; I'm aware that the k would be more appropriate, but I feel it us less interesting. Below is a photo of the blade blank. Further bulletins as events warrant.


 Attachment: 117.99 KB
[ Download ]
I'm eager to see this project! I know of very few reproductions with the Type R pommel.

Page 1 of 1

Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum




All contents © Copyright 2003-2006 myArmoury.com — All rights reserved
Discussion forums powered by phpBB © The phpBB Group
Switch to the Full-featured Version of the forum