steel in roman empire
Hello as a question what is the modern knowledge of the roman steel? How much was diffused , what was the level of theirblacksmiths?
Well, the Romans definitely had steel, some of it quite good, and they used a lot of what Mike Bishop refers to as "steely iron", a low-carbon steel or high-carbon iron. Cross-sectional analysis of sword blades reveals that they sometimes put harder edges on a softer core, but some blades were basically homogenous "mild steel".

One interesting tidbit is that lorica segmentata plates are consistently harder on the outside than on the inside, apparently accomplished with hammer-hardening. And each plate is surprisingly consistent in its thickness (though the plates are not all the same), to the point where some experts are wondering if they were *rolled* rather than hammered. So there is clearly some pretty sophisticated metalwork going on!

Matthew

Page 1 of 1

Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum




All contents © Copyright 2003-2006 myArmoury.com — All rights reserved
Discussion forums powered by phpBB © The phpBB Group
Switch to the Full-featured Version of the forum