Hafting a spear project
hi all, i'm currently profiling a haft for my long bladed spearhead and my flat buttcap from widlass but i have not money for stuff to do it properly so i'm using cement (basement floor as sanding paper works better than expecting) a file and a hand sanding machine ( took me 3 hours yesterday and did not finished the first side of the haft :lol: ).

after this project i'll have bionic arms hahaha!
Re: Hafting a spear project
Etienne Hamel wrote:
(basement floor as sanding paper works better than expecting)


:lol: I do that all the time, it works great. Though I usually use the driveway instead.
A draw knife would help and be an invaluable tool for years to come. I know here in california I can only find then in antique shops but even still, it only cost me $5.00 for it and with just a little bit of TLC it works like a champ and lets me turn out halfts and shafts

just a thought, check ebay. Even if you go to an antique shop to get it, you know what to look for and how much it is on the internet. if you plan on doing more than one project this is well worth the money

good luck
i found a knife today and i should say it work better in approximately 30 min i have done the job i did in 3 hours :eek:

Page 1 of 1

Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum




All contents © Copyright 2003-2006 myArmoury.com — All rights reserved
Discussion forums powered by phpBB © The phpBB Group
Switch to the Full-featured Version of the forum