A couple of recent projects.....
Hello all, I thought I'd share pictures of some recent projects....I've had the chance to work on some new scabbards and suspensions over the last few months, as well as this sidesword. There are lots more pictures and some descriptions at http://www.jessebelsky.com/stageswords if you are so inclined. Feedback is always welcome!


 Attachment: 153.76 KB
IMG_2148.jpg


 Attachment: 147.44 KB
IMG_2170.jpg


 Attachment: 183.37 KB
IMG_2212.jpg


 Attachment: 178.7 KB
IMG_2217.jpg


 Attachment: 173.48 KB
IMG_2239.jpg


 Attachment: 178.24 KB
IMG_2246.jpg


 Attachment: 117.67 KB
IMG_2259_2.jpg


 Attachment: 174.41 KB
IMG_2262_2.jpg

The incised leatherwork on the suspension belts is very nice! How did the back side (stiched area) of the scabbards turn out?
Well, i think they both turned out pretty well. Here are some pictures of the stitching on the backs. One of them shows the transition from one type of stitch to another.....i cut the leather a tiny bit too wide from that point down, so the stitching on the right sucked up the excess and kept it good and tight. Its well below the part of the scabbard that rests against the hip/leg, so i figured what the heck.


 Attachment: 218.42 KB
IMG_2219.jpg


 Attachment: 190.9 KB
IMG_2221.jpg


 Attachment: 151.66 KB
IMG_2269_2.jpg

Congratulations, Jesse! You've done a wonderful job and your scabbards are very nicely made. I wish I could have just 1% of your skills...

Cheers,

David
Thanks for the kind words David. I bet if you gave it a shot you'd find yourself a lot better at it than you think!
lovely work, keep it up and you'll make yourself a reputation- and possibly some money!
A few new pommels....
I was working this past week at a college in Connecticut (i'm a freelance lighting designer, so i travel a lot), and the technical director there had just acquired a huge and beautiful old South Bend lathe for about $300, in perfect working condition. What a steal! Anyhow, they were kind enough to let me spend a few hours of downtime on it so i turned some pommels i've had in mind. One is for the rapier guard its shown with, which carefully matched my drawings. The others i just freehanded with the remaining stock i had. Probably the more ovoid one will get faceted. Its proportions are a little off....
I haven't done any pommels on a lathe in ages....its sort of like drawing curves with an etch-a-sketch.


 Attachment: 60.4 KB
IMG_4493.jpg


 Attachment: 70.85 KB
IMG_4522.jpg


 Attachment: 69.22 KB
IMG_4502.jpg


 Attachment: 64.62 KB
IMG_4518.jpg


Page 1 of 1

Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum




All contents © Copyright 2003-2006 myArmoury.com — All rights reserved
Discussion forums powered by phpBB © The phpBB Group
Switch to the Full-featured Version of the forum