| myArmoury.com is now completely member-supported. Please contribute to our efforts with a donation. Your donations will go towards updating our site, modernizing it, and keeping it viable long-term.
Last 10 Donors: Graham Shearlaw, Anonymous, Daniel Sullivan, Chad Arnow, Jonathan Dean, M. Oroszlany, Sam Arwas, Barry C. Hutchins, Dan Kary, Oskar Gessler (View All Donors) |
| Author |
Message |
Lancelot Chan
Industry Professional
|
 Posted: Sun 22 Oct, 2017 12:51 am Post subject: Cutting PPR pipe cored newspapers roll |
 |
|
https://youtu.be/gP67snTye-8
There's no ending in learning. After all these years I'm still training, trying to master the more precise timing of the secondary power generation.
Trying to cut twin PPR piping cored newspapers roll, simulating arm with twin bones, with Longship armoury 5160H exblunt Dadao and sparring cuts.
Ancient Combat Association —http://www.acahk.org
Realistic Sparring Weapons — http://www.rsw.com.hk
Nightstalkers — http://www.nightstalkers.com.hk
|
|
   |
 |
|
Bram Verbeek
|
| Posted: Sun 22 Oct, 2017 10:58 pm Post subject: |
|
|
|
I'm going to start test cutting soon (limited by the amount of sharp implements I have), and this looks like a good medium.
|
|
|
|
|
Lancelot Chan
Industry Professional
|
| Posted: Sun 22 Oct, 2017 11:06 pm Post subject: |
|
|
| Bram Verbeek wrote: | | I'm going to start test cutting soon (limited by the amount of sharp implements I have), and this looks like a good medium. |
Yes, this is very good material. If you can't get it, each 2cm diameter pipe is about equivalent to 3 wimpy bamboo chopsticks.
Ancient Combat Association —http://www.acahk.org
Realistic Sparring Weapons — http://www.rsw.com.hk
Nightstalkers — http://www.nightstalkers.com.hk
|
|
|
|
|
Lancelot Chan
Industry Professional
|
| Posted: Thu 26 Oct, 2017 3:04 am Post subject: |
|
|
Here's another test on such target, even bigger this time, to simulate upper arm and shin. I used Longship 3V No Remorse, since this is the sword my sparring RSW is modeled after. It cuts through with sparring cuts no problem. The 3V also held the edge much better than the 5160H, worth the cost!
https://youtu.be/UYwQFQYT97I
Ancient Combat Association —http://www.acahk.org
Realistic Sparring Weapons — http://www.rsw.com.hk
Nightstalkers — http://www.nightstalkers.com.hk
|
|
|
|
|
Lancelot Chan
Industry Professional
|
|
|
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum
|
All contents © Copyright 2003-2025 myArmoury.com — All rights reserved
Discussion forums powered by phpBB © The phpBB Group
Switch to the Basic Low-bandwidth Version of the forum
|
This is a standard topic