Wire Inlay Tutorial
Greetings,

I just finished the the tutorial.

Take a look and let me what you think or if you have any questions.

WIRE INLAY TUTORIAL

here's a peek

[ Linked Image ]
[ Linked Image ]
[ Linked Image ]
Brilliant tutorial as always Ben. You just don't know how much I appreciate these detailed guides. My only question is - where do you get your wire?
I get my silver wire from Otto Frei jewelry supply and any hardware store for the copper.
How and when is the inlay done with respect to heat treat?
The inlay is done after heat treating the blade. This blade was differential-tempered. In the pictures in the tutorial, you can see where I lightly etched the blade so I could see where the hard and soft steel was.
Ben,
Congratulations for the inlays and THANK YOU for the great tutorial.

Jean
:D Nice tutorial. I use broken drill bits as engravers. What are angles of faces on those engravers you have?
Re: Wire Inlay Tutorial
Ben Potter wrote:
Greetings,

I just finished the the tutorial.

Take a look and let me what you think or if you have any questions.

WIRE INLAY TUTORIAL

here's a peek



Thank you so much for this tutorial!

Page 1 of 1

Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum




All contents © Copyright 2003-2006 myArmoury.com — All rights reserved
Discussion forums powered by phpBB © The phpBB Group
Switch to the Full-featured Version of the forum