FS Merctailor Gorget and Scales
Gotta keep feeding the outstanding commisions machine. I have for sale one of the 15/16th century gorgets we used to make. Made from 16 gauge steel with beveled plate edges and rolled edges where appropriate. Closes with a keyslot rivet and pin closures on either side of the top neck lame. If desired I can install straps for the attachement of shoulder harness. Will fit up to an 18 inch neck with room for the collar of an arming garment. I'm thouroughly average at 5 foot 10 inches, 180-185 pounds, not particulally large just average and this fits me fine. Like to get $180 ( less than we used to get for these ) plus the cost of shipping.

I have also been saving scrap from outstanding commision work and had enough around to make 7 dozen of the scales we used to offer. They're 1 1/2 inches wide by 2 inches long, made from 16 gauge steel with a slight 3-4 degree curve to them. Rivets are included. Like to get $25.00 plus shipping ( they'll fit in a small flate rate box for $7.00 ). I'm continuing to save scrape so i'll probably made a few more of these to make use of it.


Feel free to ask any questions. Paypal, check or money order fine.


 Attachment: 52.15 KB
gorget front reduced.jpg


 Attachment: 52.14 KB
gorget profile reduced.jpg


 Attachment: 44.44 KB
gorget open reduced.jpg


 Attachment: 58.29 KB
scales reduced.jpg

Scales are spoken for.
Re: FS Merctailor Gorget and Scales
Allan Senefelder wrote:
Gotta keep feeding the outstanding commisions machine. I have for sale one of the 15/16th century gorgets we used to make. Made from 16 gauge steel with beveled plate edges and rolled edges where appropriate. Closes with a keyslot rivet and pin closures on either side of the top neck lame. If desired I can install straps for the attachement of shoulder harness. Will fit up to an 18 inch neck with room for the collar of an arming garment. I'm thouroughly average at 5 foot 10 inches, 180-185 pounds, not particulally large just average and this fits me fine. Like to get $180 ( less than we used to get for these ) plus the cost of shipping.

I have also been saving scrap from outstanding commision work and had enough around to make 7 dozen of the scales we used to offer. They're 1 1/2 inches wide by 2 inches long, made from 16 gauge steel with a slight 3-4 degree curve to them. Rivets are included. Like to get $25.00 plus shipping ( they'll fit in a small flate rate box for $7.00 ). I'm continuing to save scrape so i'll probably made a few more of these to make use of it.


Feel free to ask any questions. Paypal, check or money order fine.


Dibs on the gorget if I can get my spaulders to attach. Allan?
Gorget is sold.

Page 1 of 1

Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum




All contents © Copyright 2003-2006 myArmoury.com — All rights reserved
Discussion forums powered by phpBB © The phpBB Group
Switch to the Full-featured Version of the forum