these are my new products. Any comments? Thanks!
Best regards, Mac
www.mac-armour.cz
Attachment: 50.15 KB
Attachment: 56.97 KB
Attachment: 60.44 KB
Attachment: 49.04 KB
Hi all,
these are my new products. Any comments? Thanks!
Best regards, Mac
www.mac-armour.cz
Attachment: 50.15 KB
Attachment: 56.97 KB
Attachment: 60.44 KB
Attachment: 49.04 KB
these are my new products. Any comments? Thanks!
Best regards, Mac
www.mac-armour.cz
Attachment: 50.15 KB Attachment: 56.97 KB Attachment: 60.44 KB Attachment: 49.04 KBI've added you to the "Industry Professionals" group and moved this topic to the Makers and Manufacturers Talk forum. This is the appropriate place for announcements from makers.
Hi Mac,
That is a great looking arm kit. How much would that cost in spring steel, say 1.5mm for the upper cannon lames and 2mm for the elbow?
That is a great looking arm kit. How much would that cost in spring steel, say 1.5mm for the upper cannon lames and 2mm for the elbow?
| Lloyd Clark wrote: |
| Hi Mac,
That is a great looking arm kit. How much would that cost in spring steel, say 1.5mm for the upper cannon lames and 2mm for the elbow? |
Hi ,
Thank you LIoyd Clark.
It was make from mild steel (1.5 mm), the price is 15 000 Czk.
It will be make for spring steel, the price is for shoulders (1.5mm) and elbow (2 mm) is 30 000 Czk (hardening for 46-48 Rc) .
Mac
| Nathan Robinson wrote: |
| I've added you to the "Industry Professionals" group and moved this topic to the Makers and Manufacturers Talk forum. This is the appropriate place for announcements from makers. |
Many thanks Nathan Robinson!
Mac
They look very nice Mac ! Are you going to make 'gutter' vambraces for the lower part or fully enclosed ones ? Whichever, they will look very nice :) Nice work and nice clean lines. If I may ask , did you raise the points of the couters or weld them ? Either way it doesn't matter they are very sweet :)
Nice work Mac !
Regards as ever,
Russ
Nice work Mac !
Regards as ever,
Russ
| Russ Thomas wrote: |
| They look very nice Mac ! Are you going to make 'gutter' vambraces for the lower part or fully enclosed ones ? Whichever, they will look very nice :) Nice work and nice clean lines. If I may ask , did you raise the points of the couters or weld them ? Either way it doesn't matter they are very sweet :)
Nice work Mac ! Regards as ever, Russ |
I does not make gutter for the lower part, because the man who have shoulders and arms have long gauntlet.
The elbow was of piece, only back part was welded .( part near the body, cca 9cm)
So, your products are very nice!!!!!!!!!!!
Best regards Mac
Page 1 of 1
You cannot post new topics in this forumYou cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum
All contents © Copyright 2003-2006 myArmoury.com — All rights reserved
Discussion forums powered by phpBB © The phpBB Group
Switch to the Full-featured Version of the forum
Discussion forums powered by phpBB © The phpBB Group
Switch to the Full-featured Version of the forum