I have for sale a set of the munnions and two 11" steel bucklers we used to make. Made from 16 gauge CR steel that have rolled and counter sunk and beveled edges where appropriate. The are strapped and include hand made buckles with steel mounts with light decrative file and chiselwork. They articulate on leathers front and middle and slot rivets in back. The curvature on these is broader at the shoulder that the munnions of an almian collar as they would go over the straps and top potion of the B&B plates to attach to a gorget. I am a 42.5 inch chest and 46.5 inches around the shoulders and they fit me fine in this manner. They have buckles at the top for attachment to a gorget but if desired I can install a pairs of eyelets for pointing for no charge. We used to get $110 for these, i'd like to get $90 plus shipping.

The bucklers are made from 16 gauge steel with hand rolled edges, hand hammered boss and hand stiched boss pads made from natural wool felt and cotton batting. They have forged handles from 1/2 inch square stock with a 3/4 twist for better grip. Like to get $65 each plus shipping ( they will fit in a medium flat rate box for $16.00 ), over $20 less than they used to sell for.


Feel free to ask questions. Paypal, check or MO are fine.

---

 Attachment: 58.99 KB



 Attachment: 54.56 KB



 Attachment: 55.72 KB



 Attachment: 58.59 KB



 Attachment: 51.21 KB



 Attachment: 58.44 KB

Well, i'll file munnions under round shilelds as something not to make again. I'll take $70 plus shipping to get rid of them.