Hello all,
I've always had a predilection to atrims and tinkers. Maybe it's time to look into a new company. What do you guys think of the Baltimore knife co?

Light?
Well balanced?
Etc.


Thank you

J

Hello,

Most of their swords are more for reenactment. They do sell a few sharpened ones from their site. Think all but one listed on Kult of Athena are reenactment.

They did a special project for the Sword Buyers Guide (SBG) members. One was a fantasy leaf blade and the other was a fantasy straight blade. I have the straight blade and it is a decent sword for the price. You can check it out on SGB to see them.

That is my only experience with the company.

I've handled a number of their swords and own a custom sword and dagger that I had Matt make for me a couple years ago. For the price they do excellent work, IMO. It's true that the majority of their stuff is made for reenactment or stage combat, but they will put edges on their swords if you want that.

As far as weight and balance, it depends on what type of sword you are looking for. Their medieval swords tend to run a little heavy, but the point of balance runs closer to the hilt than is usual, so they don't feel too heavy in the hand. Their sabers and cutlasses have a more normal weight and balance in my experience. Overall durability is pretty good, although I've only used mine to cut bottles.

I hope that helps,
Alan

I've owned a few of their swords with no complaints other than some cosmetic flaws on my SBG project sword. They are quite durable and will take a beating. However, they are a vastly different product than an ATrim or Tinker (both which I own as well). The later are much more on par with their historical counterparts than what Baltimore can offer you unless you custom commission a work from them. Additionally, as mentioned above, the weight is a bit more because the Baltimore blades are overbuilt to take considerable abuse. The PoB as is on the ones I know does tend to underpower the blade and give the weapon to neutral a feel. I do not speak for them, but I am sure they could adjust this with a custom work however.

Best of luck in making a decision! :)

They're making some of the blades for Christian Fletcher's "Heroic" line of swords. I'd assume they're of pretty decent quality.