Back when I started forging out my fullers I had two test blanks that never got completed, so I thought I would put them on the grinder and see how they turned out. As with everything I sell, I stand by my work as being 100% structurally sound. If any problem ever arises I will provide repair or replacement if the blade was not abused. What ever problems the blades have are very minor cosmetic imperfections, hence the reduced price.

The TOP blade is forged from L6, got too wide at the base, and I ended up pushing the fuller out way too much, leaving it with and unusually wide fuller base, too much profile taper, and too acute of a point. However there is still 30inches of cutting awesomeness.

Blade length - 30"
Width at shoulders - 2.3"
Tang - 6"
Weight - 1lb. 4oz.
Cost - $500, please inquire if you would be interested in basic fittings.

The BOTTOM blade is forged from W2, and is actually darn near perfect. there is a small area in the middle of the fuller that has the texture of decarb. slightly mucking up the finish.

Blade length - 30.25"
Width at shoulders - 2.2"
Tang - 5.5"
Weight - 1lb. 4oz.
Cost - $575, please inquire if you would be interested in basic fittings.

Please get in touch if you have any questions or need additional pictures.

Also $75 per blade will be donated straight to myArmoury.

---

 Attachment: 65.82 KB

Flaw on Top blade

 Attachment: 181.01 KB
[ Download ]

 Attachment: 144.5 KB
Tip of Top blade [ Download ]

 Attachment: 156.08 KB
Tip of Bottom blade [ Download ]

They look beautiful.

I just don't see how to fit it.
It looks like the fuller extend down the tang, but is still thinner than the tang.
How is one supposed to get the guard over the tang without leaving a gap at the fuller?

(Perhaps silly question, but I have just had big trouble with hilting a dagger.)

The Bottom blade is sold Payment pending.

As for hilting, the guards had an open gap where the fuller meets the guard to allow for enough room for removing the guard if needed.

Also is offering up blades that have cosmetic defect for a reduced price something that the myArmoury community feels is acceptable?