Does anyone have information on how you would put a fuller into a blade using the traditional method of blacksmithing.
thanks
You need a die ( i hope that is the correct word in English).
Traditionally you need a second person working with the die and its counterpart. A modern solution is to fix them both to a spring, so you don't need a helping hand.
Traditionally you need a second person working with the die and its counterpart. A modern solution is to fix them both to a spring, so you don't need a helping hand.
A lot of fullers were also scraped or ground. There's some good information in this thread:
http://www.myArmoury.com/talk/viewtopic.php?t...p;start=20
http://www.myArmoury.com/talk/viewtopic.php?t...p;start=20
Page 1 of 1
You cannot post new topics in this forumYou cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum
All contents © Copyright 2003-2006 myArmoury.com — All rights reserved
Discussion forums powered by phpBB © The phpBB Group
Switch to the Full-featured Version of the forum
Discussion forums powered by phpBB © The phpBB Group
Switch to the Full-featured Version of the forum