Hi gang- I’m pretty jazzed about this: I’ve just competed my second crossbow; it’s a vaguely 15th century central European bow with a flat self-prod of ash. The draw weight is 100lbs, with a 25cm draw, and 20cm power stroke; about 750 inch-pounds of power. It was pretty nerve wracking tillering the prod; I had 2 that exploded, then I realized it would help to steam and bend in a little deflex first. It shoots well and HARD, with even a bit of recoil. The tiller is maple and the tickler is also ash; the nut and inlays are all black walnut.
Attachment: 135.37 KB
Attachment: 114.64 KB
That's a lovely crossbow - I will state that you have rather strong nerves to make the nut and trigger out of wood!
Michael Beeching wrote: |
That's a lovely crossbow - I will state that you have rather strong nerves to make the nut and trigger out of wood! |
Thank you! Relooking at those photos, I realize the bridle looks pretty anemic so I’m going to redo it.
The 100 lb draw is well within the limits of the walnut nut, and I constructed the ash tickler (!) in such a way that the wood grain is oriented optimally for the load at each point. But it’s a fair point; I don’t think I would go much above 150 lbs with those components still of wood.
I’m very interested in the load limits of a self-prod with rectangular cross-section. I think the deflex is a critical part of this, so the next one I do I’ll aim for higher weight and more deflex steamed in.
Page 1 of 1
You cannot post new topics in this forumYou cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum
All contents © Copyright 2003-2006 myArmoury.com All rights reserved
Discussion forums powered by phpBB © The phpBB Group
Switch to the Full-featured Version of the forum
Discussion forums powered by phpBB © The phpBB Group
Switch to the Full-featured Version of the forum