I did a pair of legs a few years ago for a student of Roger Siggs at Rocky Mountian Sword Guild, liked them quite a bit but never got around to adding them to the catalog when they were open. They are made from 16 gauge steel, with an outwardly rolled top edge of the cuisse and beveled plate edges where appropriate. The crease of the wing on the knee copps has a little decorative file work and they come with hand made buckles and steel holders with light decorative file and chisel work. There are leather tabs at the top of the cuisse with two sets of eyelets for pointing. The pair has full length medial ridges and double wrap plates on steel hinges. These have plenty of hyper extension. The original pair didn't have wrap plates but I liked the way they looked. I was the model for them and am thouroughly average with 23 1/2 inch thighs ( the hinged wrap plates allow for size variation ), 17 1/2 inch knees and measure 33 1/2 inches from the bridge of the ankle to the point where the thigh bends at the pelvis and they fit me fine. I'd like to get $230.00 for plus shipping ( which is less than I charged for the original pair.
The two 11 inch steel bucklers are made from 16 gauge steel with hand rolled edges, hand hammered boss and hand stiched boss pads made from natural wool felt and cotton batting. They have forged handles from 1/2 inch square stock with a 3/4 twist for better grip. Like to get $65 each plus shipping ( they will fit in a medium flat rate box for $13.00 ), over $20 less than they used to sell for.
Feel free to ask questions. Paypal, check or money order are fine.
Attachment: 51.43 KB
Attachment: 60.43 KB
Attachment: 28.78 KB
Attachment: 45.71 KB
Attachment: 23.36 KB
Attachment: 26.2 KB
Attachment: 51.21 KB
Attachment: 58.44 KB
